Pando E-392, Installation Manual

Page: 121 / 136

Residual heat indication
After the switch off of a heating zone or the complete stop of the hob, the heating zones are still
hot and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
As far as the residual heat indicators are on light, don’t touch the heating zones and don’t put any
heat sensitive object on them.
There are risks of burn and fire.
Booster and double booster function
Booster [ P ] and Double Booster [ ] grant a boost of Power to the selected heating zone.
If this function is activated the heating zones work during 10 minutes with an ultra high Power.
This is foreseen for example to heat up rapidly big quantities of water, like nuddles
•
Start up / Stop the booster:
Action Control panel Display
Start up the booster
Slide to the end of the “SLIDER”
[ P ]
Or press directly on the end of
t
he “SLIDER”
Stop the booster
Slide on the “SLIDER“
[ 9 ] to [ 0 ]
•
Start up / Stop double booster
Action Control panel Display
Start up the booster
Slide to the end of the “SLIDER”
[ P ]
Or press directly on the end of
the “SLIDER”
Start up double booster Re-
press on the end of the “SLIDER” [
and P ]
Stop the double booster Slide on the
“SLIDER“
[ P ] to [ 0 ]
Stop booster
Slide on the “SLIDER“
[ 9 ] to [ 0 ]
• Power management:
The total cooking hob is equipped with an overall maximum of Booster power. When the Booster
function is activated, the electronic system
automatically regulates all “Boosters” selected to
equalise the available power to each element selected for booster. The display is blinking on [ 9 ] for
a few seconds and then shows the maximum of Booster allowed :
Heating zone selected The other heating zone: (example: power level 9)
[ P ] is displayed [ 9 ] goes to [ 8 ] and blinks
Timer
The timer is able to be used simultaneous with all heating zones and this with different time
settings (from 0 to 1H59 minutes) for each heating zone.
•
Setting and modification of the cooking time:
Action Control panel Display
Select a zone Press a zone [ 0 ]
Select the power level
slide on the “SLIDER“
[ 1 ] to [ P ]
Select theTimer Press key [ ] Timer display on
Decrease the time Press key [ - ] from the timer [ 60 ] to 59, 58...
Increase the time Press key [ + ] from the timer Time increase
After a few seconds, the [ ] display stops with blinking.
The time is confirmed and the timer starts.
121
EN