10
Turning the Scanner Off
To turn the scanner off, press and hold
for three seconds.
Now you can safely remove the SD card from the scanner.
The scanner has a power-saving feature which automatically turns the scanner off
when it’s left idle for a specified number of seconds
(if not connected to a computer)
. To
set the Power Saving time, see the “Set the Power Saving Time” section on page 17.
Cons id e rat ion s f or al l Sc an nin g
Always insert a SD card before scanning.
Do not remove the SD card or disconnect the power supply while the indicators are blinking.
If the SD card is full, the indicator light blinks red and LCD displays “Card Full”. Use another
card or delete some files on it if necessary.
The scanner only accepts SD cards in FAT16 or FAT32 file system. NTFS and other file
systems are not supported.
This scanner supports output images in JPG and PDF formats. (The date & time attributes are
always a fixed date & time assigned during production, not current date & time.)
Scanning the same original in different orientations may produce scanned images that look
slightly different in color tones and brightness. This is not a malfunction.
After beginning to feed an original into the feeder dock, the scanner pauses briefly and then
completes the scan. This is by design and is not a malfunction.
Keep the original flat and level when feeding to prevent possible jamming.
Keep originals free from finger prints, oil, dirt, and dust for optimum scanned image quality.
To prevent poor cropping effect, align original straight against left edge of the feeder slot and
ensure there is adequate space behind the feeder dock for the originals to complete the scan
feed.
The scanner runs on 2 AA Alkaline or 2 NiMH rechargeable batteries.
WARNING:
Never mix
battery types as this could cause damage or fire.
The feeder dock requires 5V 1.0A power adapter to operate.
Batteries are not required to operate the scanner when it is engaged in the feeder dock.
The wand scan mode requires you to press
to begin scanning an original, and then press
again to stop the scan.
Only the wand scan mode supports the “anti-mirror” feature.
The feeder dock’s sensor is triggered when you begin to insert an original aligned against the
left edge of the feed slot, and then the original begins to automatically feed, hesitates and then
completes the scan.
