P&C COMBI-110, Owner'S Manual

Page: 14 / 18

P.25 P.26
Care And Cleaning Care And Cleaning
Care and cleaning
Care and cleaning
Before your maintenance starts, please remove the power plug or disconnect power
and close the tap.
WARNING
- Solvents are forbidden as to avoid the being washing machine damaged, and
toxic gases are generated or exploded.
- Never use water to wash the washing machine.
- It is forbidden to use detergents containing PCMX to clean the
washing machine.
- Certain internal parts are intentionally not grounded and may present a risk of
electric shock only during servicing. Service Personnel-Do not contact the
following parts while the appliance is energized:
Electrical value,Drain Pump,
Door Lock,Dry Heater(Combo),Fan Motor(Combo).
Cleaning and Maintenance of Washing Machine Cabinet
Proper maintenance of the washing machine can extend its working life. The surface can
be cleaned with diluted non-abrasive neutral detergents when necessary. If there is any
water overflow, use the wet cloth to wipe it off immediately. No sharp items are allowed to
strike the cabinet.
Notes: formic acid and its diluted solvents or equivalent are forbidden.
Clean Internal Drum
The rust left inside the drum by metal articles can be removed immediately with
chlorine-free detergents.
Never use steel wool.
Dispose a Frozen Washing Machine
When the temperature drops below zero and your washing machine gets frozen, you may:
1.Disconnect the power supply from the washing machine.
2.Wash the tap with warm water to loosen inlet pipe or
.Pour warm water into washing drum and wait for 10 minutes.
4.Reconnect inlet pipe to the tap and check whether inlet and outlet are working normally.
Note: when the washing machine is reused, make sure the ambient temperature is above 0 C
Anti-freeze
If your washing machine is located in a room where it can get freeze easily, please drain
the remaining water inside drain pipe and inlet pipe thoroughly.
Remove the remaining water in inlet pipe :
1.Close the tap.
2.Screw off the inlet pipe from tap and put its end into the container.
3.Start up any procedure except single Wash or Drain
procedure. Water will be drained out of inlet pipe if any
for about 40 seconds.
4.Reconnect the inlet pipe to tap.
take down inlet pipe and immerse it
in warm water.
3
Remove the remaining water in drain pump
T
o avoid burning, to be done after the hot water
inside the machine has cooled down.
WARNING
Clean detergent box and grooves
Clean detergent drawer and grooves
1.Press down on the arrow on softener cover
inside the drawer.
2.Lift the clip up and take out softener cover and wash
all grooves with water.
3.Restore the softener cover and push the drawer into
position.
Clean inlet filter
Inlet filter must be cleaned if there is no
water in it when the tap is opened.
Clean the tap filter:
1.Close the tap.
2.Select any procedure except “Wash” or “Drain”
procedure.
3.Press the button “Start/Pause” and keep the
procedure running for about 40 seconds.
4.Remove the inlet pipe from the tap.
5.Use water to wash the filter.
6.Reconnect the inlet pipe.
Washing the filter in washing machine:
1.Screw off the inlet pipe from the backside of the
machine.
2.Pull out the filter with long nose pliers and reinstall
it back after being washed.
3.Reconnect the inlet pipe.
4.Open the tap and make sure there is no water leakage.
5.Close the tap.