P&C COMBI-110 Owner'S Manual Download Page 12

Page: 12 / 18

P.21

The Special function

- Time Save
-Child Lock

To avoid that the washing procedure cannot operate normally due to the mis operation by
kids during the washing procedure, you can select this function, In this case, the other
buttons except On/Off button can not work, at this state ,the machine will power off when you
press the key on/off. The machine remembers the program child lock and the program during
powered off when press the key on/off again.
Press Function and Select together 3 seconds during the running procedure, the buzzer
will beep ,Start/Pause button as well as the rotary switch are locked. Press the two buttons
for 3 seconds together and buzzer will beep to release locking. But cut off the power
supply , the kid’s protection is also release to locking. The kid’s protection will not be
cancelled after all procedures are completed.

- Delay

Delay function can be set with this button, delaying time is 0-24H.
Set the delay function:
1.Select a programme;
2.Press the Delay button to choose the time;
3.Press Start/Pause to commence the Delay operation.
Cancel the Delay function :
Press the Delay button until the display will be 0H . It should be pressed before starting the
program. If the program already started, should press the On/Off button.
Notes: If there is any break in the power supply while the machine is operating, a special
memory stores the selected programme and when the power is restarted ,press the
Start/Pause button the time continues.

- Add a garment

This operation can be executed during the washing procedure. When the drum of the
washer (dryer) machine is still rolling and there is large amount of water with high temperature
in the drum. The state is unsafe and the door cannot be opened forcefully. To press
"Start/Pause"for 3 sec. to reload, start adding the clothes in the midway function .
Please follow the steps as bellow:
1.Wait until the drum stops rotation. 2.The door lock is unlocked.
3.Close the door when the clothes are loaded and repress the"Start/Pause"button.
Notes:Don't use the Reload function when the water surface is over the edge of the inner tub
and the temperature is higher.

View of control panel

Operating Instructions

P.22

Operating Instructions

Washing clothes at first time

Before washing clothes for the first time, the washing machine shall operate
one round of the whole procedure without clothes in as follows:
1.Connect power source and water.
2.Put a little detergent into the box and close it.
3.Press the button “On/off”.
4.Press the button “Start/Pause”.
The drawer is separated as follows:
I: Pre-detergent or washing powder.
II: main detergent, softener, pre-dip,
bleaching or decontaminating products.
: washing additive, such as fabric softener or tackifier.

Put detergent into washing machine.

1.Pull out the drawer.
2.Fill pre-detergent into Case I (when necessary).
3.Fill detergent into Case II.
4.Fill softener into Case (when necessary).

Start up washing machine

Connect the power. Check if water pipes are connected properly. Open the tap completely.
Put in the clothes to be washed and fill in the detergent and tackifier. Then press the button
“Power”,Select the proper procedures and functions and press the button “Start/Pause”.

The proper washing procedures shall be selected according to the types, quantities, and
dirtiness of the clothes to be washed in combination with the following washing
temperature table.

Ⅰ

Ⅱ

Notes:
- As for the agglomerated or ropy detergent or additive, before they are poured into the detergent box,

it is suggested to use some water for dilution to prevent the inlet of detergent box from being blocked
and overflowing while filling water.

- Please choose a suitable type of detergent for the various washing temperature to get the best washing

effect with less water and energy consumption.

Select the procedure

This function can decrease

the

washing

time.

-Timed Dry