PANCONTROL PAN 1000AD, Manual

Page: 38 / 202

EN 15
Resistance measurement / Continuity test / Capacity
measurement
Note Fig. 5
Attention! Before making any measurements, make sure the circuit is
disconnected from any power source and all capacitors are properly
discharged!
•
Set the rotary switch to the position
Ω
With the function key FUNC (6.2) you switch between Resistance
measurement, Continuity test and Capacity measurement.
•
Attach the pin-plug of the black test lead to the COM-jack and the
pin-plug of the red test lead to the INPUT-jack.
•
Touch the measuring points with the probe tips.
•
For capacitors with known polarity connect the red test lead with the
anode and the black test lead with the cathode.
•
Once the reading stabilizes, read the value.
Continuity test:
If the resistance is less than about 30 Ω, you hear an
audible signal. If the circuit is open, the display shows “OL”.
Temperature measurement
•
Set the rotary switch to the position TEMP
With the function key FUNC (6.2) you switch between °C and °F.
•
Connect the device to the K-probe. Observe the correct polarity! (Red:
INPUT, Black: COM)
•
Connect the temperature probe to the device to be tested wait a few
moments and read the value displayed.
•
If necessary, use heat conducting paste.
Contactless Voltage tester (NCV)
•
Set the rotary switch to the position NCV
•
Keep the tip of the measuring device to a power outlet or a cable. In the
presence of dangerous voltage, a signal tone sounds and the LED indicator
lights up.