15
ENGLISH
A
Status indicator [STATUS]
Shows the operation status of the repeater.
On (orange):
Connected to lane A, strong signal
On (green):
Connected to lane B, strong signal
Slow Blinking (orange): Connected to lane A, weak signal
Slow Blinking (green): Connected to lane B, weak signal
Blinking (orange):
Currently registering ID to lane A or searching for lane A
Blinking (green):
Currently registering ID to lane B or searching for lane B
On (red):
No ID registered
Blinking (red):
ID registration failed
Off:
No power supply
memo
Important
●
Refer to the center module operating instructions for details on ID
registration.
B
Registration button [ID REG]
Press and hold the button to switch to ID registration mode.
Lane A: Indicator is blinking orange
Lane B: Indicator is blinking green
C
Screw cover
Used to install the repeater on a wall. Open this screw cover and tighten the screw
inside it to fix the repeater to the fixing bracket.
D
Hook grooves
Used to install the repeater on a wall. Attach these grooves to the hooks on the fixing
bracket.
E
Cable routing groove
Pass the USB cable (page 18) through this groove to fix it into place.
F
Cable tie hook
Pass the included cable tie through this hook to secure the cable.
G
Power supply connector
Used to connect the repeater to USB power adaptor. Use a USB cable for the connection.
H
Maintenance connector
Used only when maintenance is required.
memo
Important
●
Do not connect any PoE devices (hubs or routers equipped with PoE)
to maintenance connector. Doing so may cause malfunctions.
WX-CR480P_PUQX1029ZAV1_OI_en-fr.indb 15
2021/11/08 13:25:14
