23
■
Installations and Connections
Refer to qualified service personnel for details.
■
Battery Charge and Replacement
(WX-CH2050/WX-CT2020)
Refer to WX-CT2020/WX-CH2050 Operating Instructions for
details.
■
Setup Procedures
(WX-CH2050/WX-CT2020)
Note:
Setup of WX-CC2010 should only be performed by
qualified service personnel or system installers.
●
Opening the Switch Pocket
Refer to WX-CT2020/WX-CH2050 Operating Instructions for
details.
●
Channel Group Selection
Refer to p. 25 for the frequency table.
●
DIP Switch Setup
This operating instruction only describes what is not men-
tioned in WX-CT2020/WX-CH2050 Operating Instructions.
Settings of SW#2 to #5
The settings of SW#2 to #5 depend on the operation
modes. (Refer to pp. 15 to 21 for details.)
SW#2:
For selection of the operation mode (Refer to pp. 15
to 21 for details.)
ON:
Applies DDT (Double Drive Thru). If the system
connection is Operation Mode 1 to 4, select this.
OFF:
Applies SDT (Single Drive Thru). If the system
connection is Operation Mode 5 to 7, select this.
SW#3:
For the activation of the manager mode (Refer to
pp. 17, 18, and 21 for details.)
ON:
Activates the manager mode. If the system con-
nection is Operation Mode 3, 4, or 7, select this.
OFF:
Activates the normal mode. If the system connec-
tion is Operation Mode 1, 2, 3, 5, or 6, select this.
SW#4:
For the role assignment of the person who uses the
order taker unit. (Refer to pp. 17, 18, and 21 for details.)
ON:
The person is assigned as a manager.
OFF:
The person is assigned as assistant personnel.
SW#5:
For the expansion of communication area (Refer to
pp. 16, 18, and 20 for details.)
ON:
Applies the area expansion. When the communi-
cation area is expanded by more than one trans-
ceiver, select this.
OFF:
Applies the normal communication area.
●
Channel Interference Check
Refer to WX-CT2020/WX-CH2050 Operating Instructions for
details.
■
Preparation
Note:
The following procedure applies when using WX-
CT2020 Order Taker Unit and WX-C1027A Headset. If
you use WX-CH2050 All-in-One Headset, refer to the
operating instructions of the headset.
1. After loading a battery into the order taker unit, insert
the headset plug into the earphone input jack and
microphone input jack on the order taker unit.
Note:
Confirm that the plug has completely been
inserted into the jack.
PREPARATIONS
