22
Connections
Step 1
Connect the monitor cable between the mon-
itor out connector inside the dome cover and
the video in connector of the video monitor
(only when adjusting angular field of view).
Important:
The monitor out connector is provided
only for checking the adjustment of the
angular field of view on the video monitor
when installing the camera or when serv-
icing.
It is not provided for recording/ monitor-
ing use.
Step 2
Connect a power cord from a power supply.
• When using 12 V DC power supply
q
Remove 3 mm – 7 mm {1/8" – 5/32"} of
the outer jacket of the power cord from a
12 V DC power supply and twist the core
of the power cord to prevent a short cir-
cuit.
Specification of cable (wire):
AWG #16 - #28 Single core, twisted
w
Loosen the screws of the provided power
cord plug and insert the power cords into
the power cord plug until the exposed
core wires are completely hidden.
e
Tighten the screws to fix the inserted
power cords.
* Make sure that the exposed core wires
are completely hidden after tightening
the screws.
r
Insert the power cord plug to the power
cord terminals on the mounting side of
the camera.
* Make sure that the power cord plug is
inserted to the power cord terminal firm-
ly.
Monitor out connector (for adjustment)
GN
D
AU
X
AL
AR
M O
UT
AL
AR
M IN
10BASE-T/
100BASE-TX
ACT LINK
MIC
IN
12
V
AUD
IO O
UT
INIT
IAL
SE
T
12 V DC power terminal
Power cord plug
(provided as a
standard accessory)
!
@
Approx. 3 mm - 7 mm {1/8" - 5/32"}
