15
(7) White Balance (WHITE BAL)
You can select either of three modes shown below for white balance adjustment:
• Auto-Tracing White Balance (ATW1)
In this mode, the color temperature is monitored continuously and thereby white balance is set auto-
matically. The color temperature range for the proper white balance is approx. 2 600 - 6 000 K.
Proper white balance may not be obtained under the following conditions:
1. The color temperature is out of the 2 600 - 6 000 K range.
2. When the scene contains mostly high color temperature (bluish) objects, such as a blue sky.
3. When the scene is dim.
In these cases, select the AWC mode.
• Auto-Tracing White Balance (ATW2)
This mode enables the camera to trace the white balance when it is used in an area lit by sodium
lamps.
• Automatic White Balance Control (AWC)
In this mode, accurate white balance is obtained within a color temperature range of approx. 2 300 -
10 000 K.
See page 42 for the setting.
(8) Motion Detector (MOTION DET)
The motion detector detects motion in a scene by monitoring changes in the brightness level. You
can select the sensitivity level for the motion on the setup menu.
When the camera detects motion, it sends the alarm signal to the external equipment and stops at its
position for the preset dwell time.
See page 43 for the setting.
(9) Auto Focus (AF MODE)
The camera adjusts the focus automatically by sensing the center of the picture. S, M and L stand for
the size of the sensing area: Small, Middle and Large.
See page 44 for details.
MANUAL S, M, L:
Auto-focus is activated only when the AF key on the controller is pressed.
AUTO S, M, L:
Auto-focus is activated automatically while a manual pan, tilt or zoom operation is per-
formed.
Note:
If SENS UP is set to ON except x2 FIX or x2 AUTO, the AUTO (S/M/L) mode is disabled and the
MANUAL (S/M/L) mode is automatically selected.
(10) Special 2 Menu (SPECIAL2)
This menu allows you to adjust and set up the following items and functions: chroma level, aperture
level, pedestal level, black and white function, digital noise reduction function and refresh function.
You can also reset your parameters to the factory default settings.
See page 45 for the setting.
●
RS485 communication
Refer to the following pages for the communication parameter settings.
• Full/Half duplex (page 54)
• Camera units (96 units max.) (page 52)
• Transmission Speed (2 400 - 19 200 bps) (page 48)
• Termination ON/OFF (page 54)
• Parity bit, Stop bit, Flow control (page 48)
• Reset parameters (page 51)
• Wait time, Delay time, Alarm output (page 48)
