16
Installation
Connect the safety wire
If an installation area has sufficient strength (
☞
page 17), secure the provided safety wire to the
installation area.
If not, procure another wire that can substitute for the safety wire (accessory).
The following is an example of safety wire connection.
Important:
• Be sure to install the safety wire. Ask your dealer for installation.
• Take care so that the camera does not roll over. Do not remove the
camera cover film until the
installation is completed.
• When the rear sheet* comes off, fit the sheet into the rear panel of the camera. (The rear sheet
is not stuck to the camera.)
Install on ceiling
Camera mount bracket (locally procured) and the safety wire (accessory) will be used for installa-
tion.
z
Bend the ring part and the ring neck of the safety wire (accessory).
x
Engage the safety wire (accessory) with the wire engaging hole.
Safety wire
(accessory)
q
Pass the ring part of the
safety wire (accessory)
through the wire engag-
ing hole.
w
Pass the other end of the
safety wire through the ring
part of the safety wire.
INITIAL
SET
ACT
LINK
POWER
10BASE-T/
100BASE-TX
12V IN
INITIAL
SET
ACT
LINK
POWER
10BASE-T/
100BASE-TX
12V IN
INITIAL
SET
ACT
LINK
POWER
10BASE-T/
100BASE-TX
12V IN
* Rear sheet
