19
■
Indicators and buttons
A
INITIAL SET button (Initializing button)
Follow the steps below to initialize the network camera.
⑴
Turn off the power of the camera. When using a PoE hub, disconnect the Ethernet cable from
the camera. When using an external power supply, disconnect the 2P power cable (accessory)
from the 12 V DC power supply terminal.
⑵
Turn on the power of the camera while pressing the INITIAL SET button, and make sure to
release the button after approximately 15 seconds.
In about 2 minutes later, the camera will
start up and the settings including the network settings will be initialized.
Retry if the camera
does not start up normally.
IMPORTANT:
When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
A
INITIAL SET button
(Initializing button)
SD memory
card slot
G
SD memory card warning/error indicator
Dome cover
*Do not directly touch the dome cover
surface with your hands.
B
ACT indicator
SD slot cover
<Inside view of the SD memory card slot cover
(with SD memory card slot cover opened)>
C
LINK indicator
F
SD ON/OFF button
E
SD MOUNT indicator
* This illustration represents WV-S4550L
D
SD ERROR/ABF indicator
X4571L
X4571LM
SD ERROR indicator
S4550L
S4550LM
