13
Step 12
Secure the camera body to the camera mount
bracket (supplied with the camera) using a
piece of the camera fixing screw (M3, supplied
with the camera).
(Recommended tightening torque: 0.68 N·m
{0.50 lbf·ft})
Step 13
Rotate the height adjusting screw (one of 4
points) counterclockwise (in the
e
up direction
of the label) when viewing it from beneath, and
raise the camera mounting stage to the posi-
tion of the model number in use displayed on
the paper gauge.
Tightening torque: 0.1 N·m {0.07 lbf·ft}
* Do not apply equal to or more than 0.29 N·m
{0.21 lbf·ft} of torque. Failure to observe this
may cause damage.
Note:
After adjusting the camera height, remove
•
the paper gauge from this bracket, and dis-
card it.
Camera fixing screw
(M3, supplied with
the camera)
Height adjusting
screw
Paper
gauge
Step 14
Push the stopper bracket (in the lock
r
direc-
tion of the label), and lock the height adjusting
screw. Secure the stopper bracket with the
stopper bracket fixing screw.
Step 15
Remove the protective sheet from the camera
lens.
Step 16
Align the III mark of the decorative cover sup-
plied with this bracket with the III mark of the
mounting chassis, press the decorative cover
against the ceiling, and rotate the decorative
cover clockwise when viewing it from beneath
to secure the cover.
Stopper bracket
fixing screw
Stopper bracket
Height adjusting
screw
Decorative cover (sub)
III mark of mounting
chassis
III mark of
decorative cover
Decorative cover (main)
