8
Note:
When the existing anchor bolt that has been
•
installed is used for connecting the safety
wire, the use of 2 spacer nuts is helpful.
Step 4
Attach the paper gauge (accessory) to the
camera mounting stage.
Fold the double-sided tape side of the
q
paper gauge at a right angle as shown in
the drawing.
Peel off the backing from the double-sided
w
tape of the paper gauge.
Spacer nuts
Safety wire
Safety wire angle
Spacer nuts
Existing anchor bolt
Paper gauge
Folding line
Double-sided tape
Step 3
Secure the safety wire angle (accessory) to the
anchor bolt (for connecting the safety wire),
and connect the safety wire (accessory).
Mount a nut so that the safety wire angle is
q
secured on the anchor bolt.
Disconnect the safety wire from the safety
w
wire angle.
Engage the face marked
e
q
with the anchor
bolt.
Bend the face marked
r
w
.
Connect the safety wire to the safety wire
t
angle again.
Engage the nut from beneath, and secure
y
the safety wire angle with top and bottom
nuts.
Engage another nut from beneath to tighten
u
and secure the nut that was engaged from
beneath in
y
in a double nut fashion.
Upper side
Lower
side
Safety wire
e
Insert
w
Disconnect
r
Bend
Mark
w
Mark
q
t
Connect
Safety wire angle
Anchor bolt
* The nut is omitted in the illustration above.
<Image of safety wire connection>
