16
Installations/Connections
Cautions:
ONLY CONNECT THIS TO 12 V DC or 24 V AC CLASS 2 POWER SUPPLY.
Be sure to connect the grounding lead to the GND terminal.
Installation of the camera
Before starting the installation/connection, prepare the required devices and cables. Refer to
the corresponding pages for further information.
z
Make a hole in the ceiling and fix the camera mount bracket over it. (
☞
page 17)
x
Line up the ends of the cables (power cord, LAN cable and cable from an external device)
and the safety wire, and then bundle them using the provided cable tie. (
☞
page 18)
c
Attach the safety wire to the safety wire holder of the camera. (
☞
page 18)
v
Connect the power cord (from a DC 12 V or an AC 24 V power supply), a LAN cable (cate-
gory 5 or better) and an external device. (
☞
pages 21 - 23)
b
Mount the camera onto the camera mount bracket. (
☞
page 18)
n
Adjust angle of the camera, angular field of view and focus. (
☞
pages 26 and 27)
Note:
When the camera is installed just above the photogenic subject
as
q
in the illustration, it may be difficult to adjust angular field
of view focusing around the subject.
To easily adjust angular field of view focusing around the sub-
ject, increase an angle (A) as
w
.
(A)
q
w
Subject
Safety wire
Ceiling
Safety wire holder
LAN cable
Power cord
Camera mount bracket
(provided as a standard
accessory)
Cable tie (provided as a
standard accessory)
Anchor bolt x4
(not provided)
Cable from an
external device
Bundle the cables and
the safety wire together
