18
(2) Be sure to hook the camera safety wire into the bracket.
Camera Safety Wire
(3) Install the camera to the housing mounting
base. Install the camera to the housing
mounting base so that the guide pin at the
camera top will be directed toward "REAR"
engraved on the housing mounting base. Turn
the camera counter-clockwise, viewed from the
bottom, to confirm that the camera is fixed.
Securely tighten the screws* that were removed
when the housing mounting base was removed.
(Recommended tightening torque: 2.45 N·m
{1.81 lbf.ft})
* Special screw (mounting screw)
Use a hexagon wrench for the hexagon screw (M5).
View from the top
Positioning pin
Fixing screws (3 pcs.)
Camera
Protection Cover
Housing base
Poorly tightened screws may result in water
leaking into the camera or possible fire.
STEP 8
Attach the front and rear sunshields (accessory) to the
camera.
(1) Put the fingers on the dents of the front and rear
sun-shields to detach the hooks on both sides.
The sun-shield will be divided into two parts.
For loss prevention, one side of the front and
rear sunshields are linked together with a wire.
Detach the hooks.
Wire
Dents
(2) Locate the front and rear sunshields to the
position that covers the housing base.
START
LOCK
Housing Base
Front and rear sunshields (accessory)
(3) Joint both sides of front and rear sunshields.
Joint the hook and dents on the linked side, and
then joint the other side.
Safety wire
Front and rear sunshields (accessory)
Main sunshield
Important:
• Give sufficient length to the safety wire when installing.
• Fix the safety wire to a strong place, considering
the weight of the camera (4.5 k
g
{9.92 lbs}).
Positioning pin
When the camera is
attached
When the camera is secured
to the mount bracket
