-25-
Important Notice:
1. The priority for the sync modes is as follows.
1. Multiplexed Vertical Drive (VD2) (Highest pri-
ority)
2. Line-lock (LL)
3. Colour Composite Video or Blackburst Signal
(VBS)
4. B/W Composite Video or Composite Sync
Signal (VS)
5. Internal Sync (INT) (Lowest priority)
2. When the internal sync mode is to be used, select
INT. No gen-lock input signal should be supplied
to the Gen-lock Input Connector on the rear panel.
3. Whenever the multiplexed vertical drive pulse
(VD2) is supplied to the camera from an external
equipment such as a Matrix Switcher, the camera
sync mode is automatically switched to the VD2
mode.
4. When the VBS or VS gen-lock mode is to be used
select INT from this menu and supply the gen-lock
input signal to the Gen-lock Input Connector on
the rear panel.
5. The VBS gen-lock mode has its own menu for hori-
zontal and subcarrier phase adjustments. When
the cable length of the video output or the gen-
lock input is changed, the horizontal and subcarri-
er phase must be re-adjusted.
6. The VS gen-lock mode has its own menu for hori-
zontal phase adjustments. When the cable length
of the video output or the gen-lock input is
changed, the horizontal phase must be re-adjust-
ed.
7. The line-lock mode has its own menu for line-lock
vertical phase adjustment. If the camera installa-
tion is relocated, check the vertical phase adjust-
ment again since the AC line phase may be differ-
ent.
5-1. VBS Gen-lock Mode (EXT(VBS))
1. Move the cursor to the SYNC parameter and
select INT.
2. Connect the coaxial cable for the blackburst or
composite colour video signal to the gen-lock
input connector.
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER ---
AGC ON
SYNC INT
WHITE BAL ATW
LENS DRIVE DC
END SET UP ENABLE
↵
↵
↵
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER ---
AGC ON
SYNC EXT(VBS)
WHITE BAL ATW
LENS DRIVE DC
END SET UP ENABLE
↵
↵
↵
Summary of Contents for WV-CP450
Page 3: ......
