14
3
Installation of safety wire
The following example shows the installation of safety wire:
Important:
• Be sure to install safety wire between the camera and the installation position to prevent unex
-
pected injury caused by fallen camera.
• Ensure that the safety wire is installed. Consult the dealer about installation.
Attach the safety wire lug (accessory) to the screw hole of the mount
base with screw (accessory).
1
Loosen one screw in the front portion of the
camera upper case. (Either left or right)
2
Be sure to attach the safety wire lug (accessory)
with the wire lug fixing screw (M2.5 × 8 mm
{5/16 inches}) provided in the accessories.
Important:
• Be sure to attach the safety wire lug (accessory)
with the screw provided in the accessories. Using
screw of different length may cause camera drop
or damage.
•
Do not install the safety wire lug at places other than
the two screw holes of the upper case.
• Do not install the safety wire lug on the projec
-
tions of the upper case. (Install the safety wire lug
between the two projections)
• Recommended tightening torque: 0.39 N·m
{0.29 lbf·ft}.
Screws of
upper case
Wire engaging hole
Wire lug fixing
screw (accessory)
Safety wire lug
(accessory)
Engage the safety wire with the wire engaging hole.
1
Pass one end of the safety wire eyelet through the wire engaging hole.
2
Pass the other end of the safety wire through the eyelet.
Safety wire
Wire engaging
hole
PGQX1142YA_WV-CP300_G.indd 14
2012/3/30 16:53:36
Summary of Contents for WV-CP300 Series
Page 31: ...31 ...
