4
•
When using this product, be sure to mount it using a compatible mount and align the lens surface
with the desired direction.
•
This transmitter must not be co-located or operated in conjunction with any other antenna or trans-
mitter.
•
Compliance with FCC requirement 15.407(c)
Data transmission is always initiated by software, which is the passed down through the MAC,
through the digital and analog baseband, and finally to the RF chip. Several special packets are
initiated by the MAC. These are the only ways the digital baseband portion will turn on the RF
transmitter, which it then turns off at the end of the packet. Therefore, the transmitter will be on only
while one of the aforementioned packets is being transmitted. In other words, this device
automatically discontinue transmission in case of either absence of information to transmit or
operational failure.
•
Frequency Tolerance: within ±20 ppm
<For Canada>
•
CAN ICES-3(A)/NMB-3(A)
•
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following
two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
•
Data transmission is always initiated by software, which is the passed down through the MAC,
through the digital and analog baseband, and finally to the RF chip. Several special packets are ini-
tiated by the MAC. These are the only ways the digital baseband portion will turn on the RF trans-
mitter, which it then turns off at the end of the packet. Therefore, the transmitter will be on only
while one of the aforementioned packets is being transmitted. In other words, this device automati-
cally discontinue transmission in case of either absence of information to transmit or operational
failure.
•
The available scientific evidence does not show that any health problems are associated with using
low power wireless devices. There is no proof, however, that these low power wireless devices are
absolutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the
microwave range while being used. Whereas high levels of RF can produce health effects (by heat-
ing tissue), exposure of low-level RF that does not produce heating effects causes no known
adverse health effects. Many studies of low-level RF exposures have not found any biological
effects. Some studies have suggested that some biological effects might occur, but such findings
have not been confirmed by additional research. [
WV-BWC4000
] has been tested and found to
comply with ISED radiation exposure limits set forth for an uncontrolled environment and meets
RSS-102 of the ISED radio frequency (RF) Exposure rules.
•
This [
WV-BWC4000
] has been tested and meets the ISED RF exposure rules when used with the
compatible mount accessories supplied or designated for this product. Use of other accessories
may not ensure compliance with ISED RF exposure rules. Refer to Installation Guide on our web
site for further information about with the compatible mounts.
•
When using this product, be sure to mount it using a compatible mount and align the lens surface
with the desired direction.
