Panasonic WJSX550C - MATRIX SWITCHER, Operating Instructions Manual

Page: 41 / 130

43
2
SW1 Setting
These switches are used only for factory test.
Always keep these switches in the “OFF” positions
in the field.
■
Board Setting
Before installing this board, the following settings should be made by qualified service per-
sonnel or system installers.
1. Set switches (SW1) on the board to designate the data board number as shown in the
following table.
The factory default setting is Board Number 1.
1234
OFF
SW1
1234
OFF
SW3
SW100
SW150
SW200
SW250
SW300
SW350
SW400
SW450
SW5
SW6
Board
No.
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1
2
3
4
5
6
7
8
2. Set switches (SW100, SW150, SW200, SW250, SW300, SW350, SW400 and SW450) on
the board to choose either Full Duplex (FULL) or Half Duplex (HALF) communication
lines as shown in the figure.
The factory default settings are Full Duplex (FULL).
SW100 - SW450
FULL
HALF
SW5
ON
OFF
LED
1 2 3 4
OFF
SW3 SW6
1 2 PROG
Full: 4 Lines
Half: 2 Lines
3. Set switch (SW5) on the board to choose "ON" or "OFF" mode for the LED indicator.
The indicator shows that control data operations on the board are normal.
The factory default setting is ON.
4. Confirm that switches (SW3 and SW6) on the board are set as shown in the figure.
Note