Panasonic WJSX550C - MATRIX SWITCHER, Operating Instructions Manual

Page: 30 / 130

3. Set switches (SW100/SW150/SW200/SW250) on the
board to meet the character display requirement on the
monitor screen.
The factory default setting is normal (NOR).
NOR: White with Black border
REV: Black with White border
4. Confirm that switches (SW6) on the board are set as
follows.
2. Set switches (SW2/SW3/SW4/SW5) on the board to
meet the alarm reset output requirement as either Open
Collector (OPEN C.) or Pulse (VTR).
The factory default setting is Pulse (VTR).
Open Collector (OPEN C.): 16 V DC 100 mA max.
Pulse (VTR): +5 V DC approx. 500 ms
Note: Be careful when setting these switches as the
switches are not physically located on the board in
numerical order.
Switch location from the top of the board, going
downward, is: SW4 (reset out 3), SW5 (reset out 4),
SW3 (reset out 2) and SW2 (reset out 1).
Monitor
Out No.
SW1 Setting
32
2
Board
No.
●
Board Setting
Before installing this board, the following settings should be made by qualified service personnel or system installers.
1. Set switches (SW1) on the board to designate the monitor output board number as shown in the following table.
The factory default setting is Board Number 1.
1234
OFF
SW1
SW4
SW5
SW3
SW2
1 2
OFF
SW6
SW100
SW150
SW200
SW250
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1
2
3
4
5
6
7
8
1-4
5-8
9-12
13-16
1-4
5-8
9-12
13-16
• Board Numbers 5 to 8 are only used when the WJ-
AD550 Extension Unit is used.
• Board Numbers 1 to 4 should be installed in the WJ-
SX550C Matrix Switcher and Board Number 5 to 8 in
the WJ-AD550 Extension Unit.
Do not install more than 5 boards in the WJ-SX550C
Matrix Switcher.
Cautions
NOR REV NOR REV
NOR Position REV Position
PAL TEST
NOR
SW6
NTSC
OFF
1 2
These switches are used only for factory test.
Always keep these switches in the “OFF” positions
in the field.
Note
CH1
OPEN C
VTR