11
1
FEATURES
■
Log-in
To operate the Matrix Switcher System 500, a registered
operator must first supply his/her Operator Number and
Password to the system.
The operator number and password are established by
using the REGISTRATION table. See page 16 for more
details on operator number registration.
If an attempt is made to enter an operator number and
password that do not match with the registered operator
numbers and passwords, entry into this system is denied.
As shown in the examples below, there are 2 additional
attributes associated with an operator: operator level and
priority. These items are described in more detail on page
16.
Operator name:
Mike
Operator Number:
1
Operator Level:
1
Password:
07171
Priority:
1
Operator name:
Robert
Operator Number:
15
Operator Level:
13
Password:
11524
Priority:
8
Notes:
• Factory Default Setting
Operator Number:
1
Password:
12345
are registered to allow access for first time system
programming.
• An operator can be logged-in to this system from
several system controllers.
• If the main power of the Matrix Switcher is turned
off, log-in procedures must be performed again.
• If power to the system controller is turned off, the
system controller will record operating status when
power is resupplied.
■
Camera and Monitor Selection
After logging in, the desired camera and monitor combina-
tion can be selected.
Basically, any combination of camera and monitor, which
are connected to the Switcher, can be selected as shown
below.
General Procedures
1. Select the desired monitor. (Monitor and controller
are linked.)
2. Select the desired camera. (Camera and controller
are linked.)
3. The picture of the selected camera view is dis-
played on the selected monitor.
●
Monitor Selection
By selecting the monitor with the System Controller, it is
linked with the System Controller.
At this time, the camera output signal that was last supplied
to the monitor is displayed.
Press the Numeric keys (1 to 16), then press the
MON
(ESC)
key to select the desired monitor.
For example:
When selecting monitor Number 5:
Press 5, then press the
MON (ESC)
key.
1
2
3
Camera-1 Camera-2
WV-RC150
Controller
Monitor-1
Monitor-2
WJ-SX550C
System Controller WV-CU
550
B
CAM
ESC
SET
1
2
3
4
5
6
7
8
9
MON
0
Summary of Contents for WJSX550C - MATRIX SWITCHER
