49
●
Pan/Tilt Control
(Program Preset Position)
The following function requires the use of cameras
equipped with this specific feature.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Move the camera to the position to be preset by mov-
ing the Joystick Controller and pressing the lens control
buttons.
3. Select the desired preset position number by pressing
the numeric buttons.
4. Holding down the
[PROGRAM PRESET]
button, and
then press the
[CAMERA (ENTER)]
button to save a
preset position of the selected camera.
Notes:
• If the position number entered has been stored
previously, the old position will be overwritten by
the new one.
• This function is disabled when the WV-CS600
Series or WV-CS650 Series Camera is connected
to the Encoder.
●
Pan/Tilt Control (Call Preset Position)
The following function requires the use of cameras
equipped with this specific feature.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Select the preset position number by pressing the
numeric buttons.
3. Press the
[CALL PRESET]
button to move to the pre-
set position of the selected camera on the active moni-
tor.
Note:
To be able to use the above function, the preset
position number must have been set for that cam-
era.
PROGRAM
PRESET
CALL
PRESET
AUX1 OFF
ALM S
CAM ID
T&D
AUX1 ON
VLD S
GEN
WIPER
SYS S
AUX2 OFF
ALM H
AUX2 ON
VDL H
ALL
SHIFT
BLK
EXIT
CLEAR
(ESC)
DEF OFF
DEF ON
CAMERA
(ENTER)
AUTO
PAN
MON STATUS
PROGRAM
PRESET
CALL
PRESET
AUX1 OFF
ALM S
CAM ID
T&D
AUX1 ON
VLD S
GEN
WIPER
SYS S
AUX2 OFF
ALM H
AUX2 ON
VDL H
ALL
SHIFT
BLK
EXIT
CLEAR
(ESC)
DEF OFF
DEF ON
CAMERA
(ENTER)
AUTO
PAN
MON STATUS
Summary of Contents for WJMPU955 - PROCESSING UNIT - TMU
