Panasonic WJMPU955 - PROCESSING UNIT - TMU, Operating Instructions Manual

Page: 33 / 62

33
●
Pan/Tilt Control
(Program Preset Position)
The following function requires the use of cameras
equipped with this specific feature.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Move the camera to the position to be preset by mov-
ing the Joystick Controller and pressing the lens control
keys.
3. Select the desired preset position number by pressing
the numeric keys.
4. Holding down the [PGM PRESET] key, and then press
the [CAMERA (ENTER)] key to save a preset position
of the camera.
Notes:
• If the position number entered has been stored
previously, the old position will be overwritten by
the new one.
• This function is disabled when the WV-CS600
Series or WV-CS650 Series Camera is connected
to the Encoder.
●
Pan/Tilt Control (Call Preset Position)
The following function requires the use of cameras
equipped with this specific feature.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Select the preset position number by pressing the
numeric keys.
3. Press the [CALL PRESET] key to move to the preset
position of the selected camera on the active monitor.
Note: To be able to use the above function, the preset
position number must have been set for that cam-
era.
INFORMATION
Entry:48
INFORMATION
Prg Preset48
LOGOUT
AUX1 OFF AUX1 ON
CALL
PRESET
PGM
PRESET
C A M
P O S I
D I G I TA L
O U T
DEF OFF DEF ON
AREA
AUX2 OFF AUX2 ON
CAMERA
(ENTER)
AUTO PAN
CAM ID
VLD S
T&D
ALM S
GEN
SYS S
(ALARM)
0
8 7
MSTATUS
VLD H
ALL
ALM H
BLK
5
9
6 4
2 3 1
SHIFT
CLEAR
(ESC)
EXIT
INFORMATION
Entry:52
INFORMATION
Preset 52
LOGOUT
AUX1 OFF AUX1 ON
CALL
PRESET
PGM
PRESET
C A M
P O S I
D I G I TA L
O U T
DEF OFF DEF ON
AREA
AUX2 OFF AUX2 ON
CAMERA
(ENTER)
AUTO PAN
CAM ID
VLD S
T&D
ALM S
GEN
SYS S
(ALARM)
0
8 7
MSTATUS
VLD H
ALL
ALM H
BLK
5
9
6 4
2 3 1
SHIFT
CLEAR
(ESC)
EXIT