59
The status display will indicate "*
→
PLAY" while playing
back the images recorded with a rate different from the
preset.
• The suffix "xxx" following "SP-" is specified in REC
MODE TABLE in the ADDENDUM attached to the man-
ual.
1. Select a recording mode. Audio data will be recorded
when a mode with hyphen A is selected.
Available recording modes:
SF, FQ, NQ, EX, SP, SF-
A, FQ-A, NQ-A, EX-A, and SP-A
2. When SP or SP-A is selected, specify a recording rate
(REC RATE).
Available recording rates:
From 0.1 to 30 FPS
3. When SP or SP-A is selected, specify a recording quali-
ty (REC QUALITY).
Available recording qualities:
SUPER FINE, FINE,
NORMAL, EXTENDED
8
Alarm Recording Mode Setup (ALM REC MODE)
Recording of alarm events arising within the time zone
specified by the program will start with the preset parame-
ters.
Refer to "PROG NO. SETUP" described above for operating
procedures and available parameters, since they are very
similar.
8
Pre-alarm Recording (PRE ALM REC)
Available times (seconds):
0S, 1S, 2S, 3S, 4S, and 5S
8
Post-alarm Recording (POST ALM REC)
Available times (seconds):
5, 10, 20, 30
Available times (minutes):
1, 1.5, 2, 3, 6
Manual:
Recording continues until the [REC STOP] but-
ton is pressed, or the RESET IN signal is supplied to
the rear panel.
Continue:
Recording continues while the alarm input is
active, or at least for 10 seconds if the input turns
inactive earlier.
8
Dynamic Recording (DYNAMIC REC)
ALM-MULTI:
Alarm activated channels are recorded
with priority over others.
OFF:
All channels are recorded with the same priority.
■
Trigger Action Setup (TRIGGER
ACTION SETUP)
8
Mode (MODE)
OFF:
Disables alarm recording, logging, or warning.
REC&ALARM:
Enables all alarm recording, logging
and warning.
REC:
Enables alarm recording and logging, but dis-
ables warning.
Click the [SET] button when items have been set properly.
■
Camera Recording Setup (REC
CAMERA SETUP)
Click CAMERA REC SETUP in the system setup window to
open the menu.
This menu is provided for the purpose of saving disk
space. Each camera channel can be recorded only when
an alarm operates, while it will not be recorded in non-alarm
status.
ALARM-ONLY:
Records the camera channel only
when the alarm operates.
Summary of Contents for WJHD200 - Digital Disk Recorder
Page 52: ...52 ...
Page 53: ...53 WJ HD200 NETWORK OPERATION ...
Page 77: ...77 SPECIFICATIONS APPENDIX ...
