29
How to use the terminals of the ALARM/CONTROL connector
This connector is used when connecting an external device such as a sensor that outputs alarm signals or when installing an
external alarm device such as a buzzer or a lamp. The connector to be used should be compatible with the pin array.
Pin array
The pin array is different from other Panasonic recorders. Make sure
that the connection is correct referring to the following.
Pin No.
Signal
Operation
Remarks
1
Alarm input 1
Event action will be performed according to the
settings.
Make contact input
2
Alarm input 2
3
Alarm input 3
4
Alarm input 4
5
Alarm input 5
6
Alarm input 6
7
Alarm input 7
8
Alarm input 8
9
Alarm input 9
10
Network error output*
Signal output upon detection of a broken Ethernet
link
Open collector output
24 V DC max., –100 mA
11
Alarm reset input
Canceling the alarm display
Make contact input
12
N/A
13
Signal ground
14
Signal ground
15
Face matching output
Signal output at the occurrence of a face
matching alarm
Open collector output
24 V DC max., –100 mA
16
HDD error output*
Signal output upon detection of an HDD error
17
Camera error output
Signal output upon detection of a camera error
18
Recorder error output*
Signal output upon detection of a recorder error
19
Recording error
output*
Signal output upon detection of a recording error
20
Time adjustment
signal input
According to the signal input from the other
device, the time of this recorder will be adjusted
to the hour (00 minutes 00 seconds).
Make contact input
21
Alarm output
Alarm signal will be supplied at an event
occurrence (Except for a face matching alarm)
Open collector output
24 V DC max., –100 mA
22
N/A
23
N/A
24
N/A
25
+5 V output
+5 V output
200 mA max.
* Refer to the "About the error logs and the network logs" (
☞
Operating Instructions (PDF)) for further information about each
error output.
About the connector
1
13
25
14
ALARM/CONTROL
