33
Step 4
Insert the HDD bracket with the hard disk drive all the way
into the HDD slot, and secure the HDD bracket with the
screws removed in Step 2.
HDD bracket screw
Replace the hard disk drives
When replacing a hard disk drive with another one, it is necessary to perform the removal process. In this case, do the following.
Step 1
Perform the removal process of the hard disk drive.
(
☞
Operating Instructions (PDF))
Step 2
Turn off the power of the recorder. (
☞
Page 35)
Step 3
Pull out the HDD bracket from the rear panel of the recorder
by referring to Step 2 of "Install the hard disk drives"
(
☞
page 32).
Step 4
Install the hard disk drive into the HDD bracket by referring
to Step 3 of "Install the hard disk drives" (
☞
page 32).
Step 5
Insert the HDD bracket with the hard disk drive into the HDD
slot by referring to Step 4 of "Install the hard disk drives" (
☞
page 33).
Step 6
Turn on the power of the recorder. (
☞
Page 34)
New hard disk drive will be formatted automatically.
→
→
When the formatting is completed, the hard disk drive
will become operable.
When the hard disk drive is formerly used for recording,
perform the link process (
☞
Operating Instructions
(PDF)) on the "HDD management" page.
The status of hard disk drive can be checked on the
setup menu - the "Maintenance" page - the "HDD infor-
mation" tab. (
☞
Operating Instructions (PDF))
Step 5
Turn on the power of the recorder. (
☞
Page 34)
New hard disk drive will be formatted automatically.
→
→
When the formatting is completed, the hard disk drive
will become operable.
When the hard disk drive is formerly used for recording,
perform the link process (
☞
Operating Instructions
(PDF)) on the "HDD management" page.
The status of hard disk drive can be checked on the
setup menu - the "Maintenance" page - the "HDD infor-
mation" tab. (
☞
Operating Instructions (PDF))
