64
■
NW link down detection
Select "On" or "Off" (default) to enable or disable the
disconnection detection of the network line connected
to the camera/client PC port at the rear of the recorder.
■
Bandwidth control
Set the maximum transmission rate from the following.
Unlimited (default)/32kbps/64kbps/128kbps/256kbps/
512kbps/ 1024kbps/2Mbps/5Mbps/10Mbps
The bandwidth will not be controlled when live images
are transmitted in MPEG-4 format.
■
Port forwarding
Select "On" or "Off" to determine whether or not to set
the port forwarding. When selecting "On", click the
[Setup>>] button.
■
HTTP port number
Designate the HTTP port number to be used to transmit
images from the recorder. A number from 1 - 65535 is
available. Normally "80" is to be designated.
Note:
• Depending on the network settings of the LAN or
Internet service provider, network communication
cannot be established if the http port number has
been changed. In this case, refer to the network
administrator.
The following port numbers and the port numbers
used for the FTP port, for the site alarm setting, and
for the port forwarding are unavailable for the HTTP
port number.
20, 21, 23, 25, 42, 53, 67, 68, 69, 79, 105, 110, 123,
161, 162, 546, 547, 995, 10001, 10002, 10003,
10004, 10005, 10006, 10007
■
FTP port number
Designate the FTP port number. A number from 1 -
65535 is available.
Normally "21" is to be designated.
The following port numbers and the port numbers used
for the HTTP port, for the site alarm setting, and for the
port forwarding are unavailable for the FTP port num-
ber.
20, 23, 25, 42, 53, 67, 68, 69, 79, 80, 105, 110, 123,
161, 162, 546, 547, 995, 10001, 10002, 10003, 10004,
10005, 10006, 10007
Setup items
7
Click the [Setup >>] button of "static route".
The "Static route" window will be displayed.
8
Configure each setting item.
Refer to the table "Static route" for further informa-
tion about the setting items on the page 66.
9
Click the [Set] button.
