4. Operating Instructions of System
System status check mode
1. Press check.
(The display shows STATUS.)
2. Press UP or DOWN to check the selected mode.
· Dry concrete (does not show during normal operation)
· The Water Inlet Temperature
· Tank Temperature
· Compressor Running Frequency
· Error History
· Heat mode total power consumption (Up to 999 days)
· Cool mode
*1
total power consumption (Up to 999 days)
· Tank mode total power consumption (Up to 999 days)
· Press
to exit the STATUS mode.
*Note
Once the STATUS mode is entered, the display shows STATUS.
· The STATUS mode cannot be activated when the display shows
SETTING.
· The total power consumption is an estimated value based on AC 230
V and may differ from value measured by precise equipment.
· In normal operation, the , and buttons are not in use.
Holiday mode
· By setting the day (s) in holiday mode, it promotes energy saving
while you are on holiday, and enables the system to resume at the
preset temperature after your holiday.
· Ensure that the system is OFF before setting.
· The system will resume operation automatically at 00:00 am after
the holiday.
· The day the HOLIDAY mode was set is counted as day 1.
Example:
Setting the holiday mode on June 21, 08:00 am. By setting 3 days,
the system resumes operation on June 24, 00:00 am.
1. Press
to enter the HOLIDAY mode.
2. Press UP or DOWN to set the desired days.
(Setting range: 1 day ~ 999 days)
3. Press to confi rm the setting.
* Note
Press
or wait 30 seconds to exit the HOLIDAY mode.
Operating Instructions (Controller)
Desired days
The system is turned off by an external switch.
8
UK_MANUAL_B.indd 8
29/07/15 12:18
