For your safety
To prevent severe injury and loss of life/property,
read this section carefully before using the product
to ensure proper and safe operation of your
product.
WARNING
Preventing fire, electric shock and short circuits
R
Leave installation work to the dealer.
Installation work requires technique and
experiences. Failure to observe this may
cause fire, electric shock, injury, or damage
to the product. Consult the dealer.
R
Electrical connection work should be
performed by certified personnel only.
Certification is required for performing
electrical connection work. Consult your
dealer.
R
Use only the specified power supply unit and
AC cable.
R
Do not attempt to disassemble or modify this
product. Contact an authorised service centre
for repairs.
R
Never install wiring during a lightning storm.
R
Do not connect non-specified devices.
R
Do not connect a power cable to a terminal that
is not specified in this guide.
R
When opening holes in walls for installation or
wiring, or when securing the power cable, make
sure you do not damage existing wiring and
ductwork.
R
Do not make any wiring connections when the
power supply is turned on.
R
Do not use the supplied power supply unit for
outdoor installations (it is for indoor use only).
R
Do not install the main monitor and power
supply unit in the following places:
– Places where the main monitor and power
supply unit may be splashed with water or
chemicals.
– Places where there is a high concentration of
dust, or high humidity.
R
Do not perform any actions (such as fabricating,
twisting, stretching, bundling, forcibly bending,
damaging, altering, exposing to heat sources, or
placing heavy objects on the power cable) that
may damage the power cable. Using the
product with a damaged power cable may
cause electric shock, short circuits, or fire.
Contact an authorised service centre for repairs.
R
When existing chime wires are used, it is
possible that they contain AC voltage.
Contact an authorised service centre.
Preventing accidents and injuries
R
Do not install or use the product in health care
facilities if any regulations posted in the area
instruct you not to do so. Hospitals or health
care facilities may be using equipment that
could be sensitive to external RF (radio
frequency) energy.
R
Do not install or use this product near
automatically controlled devices such as
automatic doors and fire alarms. Radio waves
emitted from this product may cause such
devices to malfunction, resulting in an accident.
CAUTION
Preventing electric shock
R
If the wiring is underground, do not make any
connections underground.
R
If the wiring is underground, use a protection
tube.
R
If the wiring is outdoors, use a protection tube or
a surge protector.
Preventing injury
R
Install the product securely adhering to the
instructions in this guide to prevent it from falling
off the wall. Avoid installing onto low-strength
walls, such as gypsum board, ALC (autoclaved
lightweight concrete), concrete block, or veneer
(less than 18 mm thick) walls.
2
