2-2 How to make wiring connections
While pressing on the button (
F
) with a
pointed object such as a screwdriver, insert
the wire into the terminal connector (
G
). (To
disconnect a wire, while pressing on the
Button (
F
), pull out the wire.)
G
H
I
F
H
Bare wire at tip 9mm
I
Wiring from doorphone
Important:
Do not connect the power cable.
(Damage may occur.)
3
Mount the main monitor to the mounting
bracket.
3-1 Line up the tab on the bottom of the
bracket with the groove on the main monitor.
3-2 Line up the tab on the top of the bracket
with the groove on the main monitor, and push
the main monitor down until it is secure.
Installing the relay box
Wiring when you connect the main monitor cable
and electric lock using relay box
C
B
A
A
9 mm
B
25 mm
C
7 mm
Front view
R1 R2 R3
1
2
5
4
R1 R2 R3
1
2
1
2
S1 S2
S3 S4
9
button
8
6
k
7
Relay box (with cable cover removed)
Top view
Bottom view
j
l
m
L
Cable binder hole
1
Strip the cables from main monitor (
A
) and
cable from electric lock (
B
,
C
)
2
Remove the screw (
D
) and then remove the
cable cover (
E
).
3
Connect the cables from the electric lock (
F
,
G
: if 2 electric locks are connected) to the
electric lock terminal (
J
) on the top of the
relay box and then secure the wires by
tightening the screws (
I
).
R
Recommended torque: 0.45 N·m
{4.6 kgf·cm}
4
Use the cable binder (
H
) (accessory) to
secure the cables from electric lock (
F
,
G
)
(double-coated area) to the relay box.
5
Make sure to replace the cable cover (
E
).
6
While pressing on the button with a pointed
object such as a screwdriver, insert the cable
from main monitor (
K
) into the main monitor
terminal connector (
M
). (To disconnect a
cable while pressing on the button, pull out the
cable.)
When installing on a wall
For more information, refer to "Attach to the DIN
rail" (page 12) and "Wall mounting" (page 13).
15
