Panasonic VL-CM850A, Operating Instructions Manual

Page: 12 / 40

Displayed when there is not much power remaining in the batteries of the Wireless
Camera.
Signal/battery information
You can display and check the signal and remaining battery power of the Wireless Camera and Monitor
with the following operations.
1
Press M MENU N , then select “
SIGNAL/BAT
” by pressing MFN or MEN .
2
Press M N (Monitor button) ( “
OK
” ).
3
Press MEN ( “
RENEW
” ) to display the latest signal status and remaining battery power information.
4
To finish the operation, press M MENU N 2 times.
Note:
R The M MENU N button will light in red to inform you when the signal is weak or if the remaining battery
power is running low. If the M MENU N is pressed at this time, the light goes out and the signal/battery
information screen is displayed.
Signal status symbols
Good Bad Out of range
*1
*1
*1 Use within this range.
Note:
R When the Wireless Camera or Monitor is out of range, move the Monitor to an area with a good signal.
Remaining battery power symbols
Lots Little Out of power
*1 *1
*1 Use within this range.
Note:
R When the batteries of the Wireless Camera run out of power, exchange them with new batteries
(page 15, 22).
R When the Wireless Camera is (Out of range), the remaining battery power symbol of the Wireless
Camera is not displayed.
12
Getting Started