5
Allow sufficient space around the
Display Unit for radiated heat
Minimum distance
10
10
10
3
(cm)
When using the pedestal, keep the space between the
●
bottom of the Display Unit and the surface where the
Display Unit is set.
In case of using Wall-hanging bracket, follow the manual of it.
●
Radio waves
Do not place the unit in any medical institutions or locations
●
with medical equipment. Radio waves from the unit may
interfere with the medical equipment and cause accidents
due to the malfunction.
Do not use the unit near any automatic control equipment
●
such as automatic doors or fire alarms. Radio waves from
the unit may interfere with the automatic control equipment
and cause accidents due to the malfunction.
Keep the remote control, Tuner Box and Wireless Unit away
●
at least 22 cm from the location where a cardiac pacemaker
is implanted. Radio waves from the unit may interfere with
the operation of the pacemaker.
Do not disassemble remote control, Tuner Box or
●
Wireless Unit. It may cause troubles such as difficulties in
communication.
IMPORTANT:
THE MOULDED MAINS PLUG
FOR YOUR SAFETY, PLEASE READ THE FOLLOWING
TEXT CAREFULLY.
The unit is supplied with a moulded three pin mains plug for
your safety and convenience. A 10 amp (Tuner Box) / 13 amp
(Display Unit) fuse is fitted in this mains plug. Shall the fuse
need to be replaced, please ensure that the replacement fuse
has a rating of 10 amps (Tuner Box) / 13 amps (Display Unit)
and that it is approved by ASTA or BSI to BS1362.
Check for the ASTA mark
ASA
or the BSI mark on the body
of the fuse.
If the mains plug contains a removable fuse cover, you must
ensure that it is refitted when the fuse is replaced.
If you lose the fuse cover the mains plug must not be used
until a replacement cover is obtained.
A replacement fuse cover may be purchased from your local
Panasonic dealer.
Do not cut off the mains plug.
The supplied mains lead and moulded plug are designed to
be used with the unit to avoid interference and for your safety.
If the socket outlet in your home is not suitable, get it changed
by a qualified electrician.
If the plug or mains lead becomes damaged, purchase a
replacement from an authorized dealer.
WARNING: – THIS TV MUST BE EARTHED.
How to replace the fuse.
Open the fuse compartment with a
screwdriver and replace the fuse.
Notes
Do not display a still picture
■
for a long time
This causes the image to remain on the
plasma screen (“image retention”).
This is not considered a malfunction and is
not covered by the warranty.
Typical still images
Channel number and
●
other logos
Image displayed in
●
4:3 mode
Video game
●
Computer image
●
To prevent image retention, contrast is
lowered automatically after a few minutes
if no signals are sent or no operations are
performed. (p. 90)
Auto power standby function
■
If no signal is received and no operation
●
is performed in Analogue TV mode for 30
minutes, the unit will automatically go to
standby mode.
The unit will automatically go to Standby
●
mode if there are no signal and no
operation between the Display Unit and
the Tuner Box for a while.
Tuner Box - after 1 minute
Display Unit - after 10 minutes
Keep the unit away from these
■
types of equipment
Electronic equipment
●
In particular, do not place video
equipment near the unit. (Electromagnetic
interference may distort images / sound.)
Equipment with an infrared sensor
●
This unit also emits infrared rays. (This
may affect operation of other equipment.)
Adjust the panel to your desired
■
angle
(TX-P46Z1B)
Ensure that the pedestal does not hang
●
over the edge of the base even if the TV
swivels to the full rotation range.
Do not place any objects or hands within
●
the full rotation range.
10
˚
10
˚
(View from the top)
500 mm
383 mm
Set the mark at the centre as
illustrated, to ensure full degree
rotation in either direction.
Visible part of the pedestal will remain
●
parallel to the TV even when rotated.