HDMI 4
AV3
L
V
S-V
PC AUDIO
via AV3
R
PC
16
Identifying Controls
Display Unit
Tuner Box
Wireless Unit
Remote control signal receiver for the connected equipment’s remote control to
operate the TV
Function select
Volume / Contrast / Brightness /
●
Colour / Sharpness / Tint (NTSC mode) /
Bass / Treble / Balance /
Auto Setup (p. 40 and p. 41) /
Remote Pairing (p. 81)
Timer LED
Active for Timer Programming or Standby for Direct TV Recording: orange (flash)
●
Timer Programming On: orange
Power LED
Standby: red
●
On: green
Power LED
Standby: red
●
On: green
When using the remote control, indicates the TV has received a command.
●
Mains power On / Off switch
Turn the Display Unit On or Off.
●
When turning Off the Display Unit,
Tuner Box will also be turned to
Standby mode after 1 min.
Standby switch
Turn the Tuner
●
Box on or off to
standby mode
Selects channel in sequence
Changes the input mode
HDMI4 terminal
(p. 82)
SD Card slot
(p. 68)
AV3 terminals
(p. 82)
Headphones jack
(p. 82)
PC terminal
(p. 82)
Selects channel in sequence
Volume Up / Down
C.A.T.S. (Contrast Automatic Tracking System) sensor
Senses brightness to adjust picture quality when
●
“Eco Mode” in the Picture Menu is set to “On” (p. 36)
Wireless Transmitter
Wireless Receiver
On and no communication : Red
On and communication state good : Green
On and communication state not good : Orange
Indicates malfunction : Red (blinking)
On and no communication : Red
On and communication state good : Green
Indicates malfunction : Red (blinking)
When the orange LED is lit, check the connection and transmission range. (p. 12 and p. 13)
●
When the red LED is blinking, turn the power of the Tuner Box and Display Unit off and then on again.
●
If the problem is not resolved, consult your local Panasonic dealer.
