33
[Setting example: To change torque boost level from 5 (%) to 15 (%)]
[Setting precautions]
1. During operation, the parameters other than those that can be changed
will show data, but the data cannot be changed.
2. If a stop signal is input while changing the data and the inverter stops, the
"operation preparation completed" state will be returned to.
3. If the inverter stops at 0V while the data is being changed, the function
setting will be returned to the "0V stop state".
4. If the inverter starts operation while the data is being changed in the "0V
stop state", the "output frequency, current display mode" will be returned to.
Operation state (for 50Hz operation)
Press the SET button to display the parameter P05 data.
(The main display will flicker)
Press the
(up) button four times, and change the parameter
No. to P05.
Press the MODE button three times, and enter the "function
setting mode".
MODE
Press the
(up) or (down) button to set the data display value
to "15". (The main display will flicker)
Press the SET button to set the data.
Press the MODE button to enter the "output frequency, current
display mode". (The display will not change unless the MODE
button is pressed.)
Control m
o
tor with
current data
Control m
o
tor
w
ith new
data
1
0
P
5
0
P
5
0
6
0
P
5
0. 0
5
1
5
0. 0
MODE
SET
SET
