Panasonic VDR-D105, Operating Instructions Manual

Page: 87 / 108

87
LSQT1040
Troubleshooting
Othe
rs
Problem Check points
A function indication
such as mode indication,
remaining time
indication, or elapsed
time indication is not
shown.
≥ If you set [SETUP]
>
[DISPLAY]
>
[OFF], indications other
than warnings and date indications disappear.
Recording does not start
although power is
supplied to this unit and
the disc is correctly
inserted.
≥ Is the DVD-RAM or the DVD-RW (VR format) write-
protected?
# Release the protection. (
l
72) If the DVD-RAM or DVD-RW
(VR format) was protected on another device, release the
protection on the same device.
≥
Has the DVD-RW (Video format) or DVD-R been finalized?
#
After finalizing, the discs become play-only and cannot
record. If you un-finalize a DVD-RW (Video format), it can be
used for recording. (
l
71)
≥
Is the memory of the disc full?
# If the disc has no more available memory, free up some
memory by deleting unnecessary scenes (
l 56) or use a
new disc.
≥
Is the unit set to the disc recording mode?
#
No recording is possible unless the mode dial is at .
≥
Is the disc cover open?
# If the cover is open, this unit may not operate normally. Close
the disc cover.
Recording starts but
stops immediately.
The playback picture
breaks up for a moment.
≥
Is the disc scratched or dirty?
#
Clean the disc. ( l 21)
≥
The unit is hot. Follow the messages on the display.
To use the unit again, turn the unit off and leave it for a
while.
Auto focus function does
not work.
≥ Is manual focus mode selected?
#
Set the AUTO/MANUAL/FOCUS switch to AUTO.
≥
Are you trying to record a scene which is hard to bring into
focus in auto focus mode?
# There are some recording subjects and surroundings for
which the auto focus does not operate correctly. (
l 94) If so,
use the manual focus mode to adjust the focus. ( l 49)
≥
Is the MagicPix function set?
# When the MagicPix function is working, focusing shifts into
the manual mode.
D105(P)eng.book 87 ページ ２００６年１月１６日 月曜日 午後４時１分