16
4.4.3.3.
Concerning the Screws and Bolts Used
4.4.4.
Installing the Wall Mounting Plates
(1) When obtaining anchors and bolts locally, be absolutely sure
that they satisfy the required specifications.
(2) Use the values recommended by the manufacturer of the
anchors used for the depth to which the anchors are to be
embedded in the wall.
(3) Use M6 bolts when the anchors have internal screw threads.
(4) Ensure that the length of the M6 bolts provides an interfitting
length of at least 1.5 times the bolt diameter.
(5) Ensure that the M6 bolts do not strike the bottoms of the
anchors, and check that they have been tightened up securely.
Note:
Recommended tightening torque: 5.2 N•m (53 kgf•cm)
1. Using the measuring tape and level, mark the 8 locations to
insert the screws.
2. Drill 8 holes for the wall mounting plates.
• Drill holes that are appropriate for the anchors you are using.
• Use a dust pump to clean the holes after drilling to make sure
no scraps remain inside the holes.
3. Drive the 8 Anchors
(WS1)
into the holes.
4. Install the Wall Mounting Plates (Left) and (Right) to the wall
with the 4 Bolts, 4 Flat Washers (diameter of 16 mm (0.63 in.))
, and 4 Spring Washers
(WS2).
Note:
The remaining 4 Bolts are used after installing the elite
Panaboard on the wall.
5. Mount the elite Panaboard on the wall.
Refer to the section 4.6 “Assembling the elite Panaboard”.
Summary of Contents for UB-T580
