Panasonic U-26PE1U6, Technical Data & Service Manual

Page: 294 / 297

6-11 6-10
6. Test run
<Procedure of CZ-RTC3 / CZ-RTC5>
<Procedure of CZ-RTC4>
1. Keep pressing the , and
for 4 or more seconds.
buttons simultaneously
The “Maintenance func” screen appears on the LCD display.
2. Press the or button to see each
menu.
If you wish to see the next screen instantly,
or press the
Select “9. Auto address” on the LCD display
and press the
button.
3. The “Auto address” screen appears on the LCD
display.
Change the “Code no.” to “A1” by pressing the
or button.
4. Select the “O/D unit no.” by pressing the or button.
Select one of the “O/D unit no.” for automatic address by pressing the or button.
Then press the button.
Approximately about 10 minutes are required.
When automatic address setting is completed, the units return to normal stopped status.
Auto address
Code no. O/D unit no.
Sel. Next
20:30 (THU)
1 A1
CZ-RTC3 / CZ-RTC5
START
[ ]
20:30 (THU)
Maintenance func
10. Set elec. consumption
12. Check touch key
Sel. Page [ ] Confirm
20:30 (THU)
11. Set touch key
9. Auto address
button.
Press the remote controller timer time
button and
button at the same time.
(Press and hold for 4 seconds or longer.)
Next, press either the temperature setting
button. (Check that the item code is “A1”.)
Use either the
button to set the system No. to
perform automatic address setting.
Then press the
button.
(Automatic address setting for one refrigerant system
begins.) (When automatic address setting for one
system is completed, the system returns to normal
stopped status.)
<Approximately 4 – 5 minutes is required.>
” is (During automatic address setting, “
displayed on the remote controller.
This message disappears when automatic address
setting is completed.)
Repeat the same steps to perform automatic address
setting for each successive system.
/
4
5
3
2
1
1
2
3
4
4
CZ-RTC4
6
SM830203-04.indb 10 15/10/14 16:25:10