Panasonic TY-CE85PS12, Installation Instructions Manual

Page: 19 / 124

19
English
Caution
The ceiling unit includes some components common to the “left-side” and “right-side” subassemblies.
During assembly, the bolt-inserting direction for one subassembly should be opposite to that for the other so that the
nuts are located inside when the Plasma Display is installed.
(In this manual, the procedures of assembling the “right-side” subassembly when viewed from the front of the
Plasma Display are shown in the figures below.)
Preparation of components
Preparation of M16 bolts (80 mm)
㊍
(14 sets)
Install one plain washer
デ
and one collar
ㅃ
in that order, on each M16 bolt (80 mm)
ヂ
.
デ
ㅃ
ヂ
Preparation of M8 bolts (60 mm)
㊎
(22 sets)
Install one spring washer
ニ
and one plain washer
ナ
in that order, on each M8 bolt
(60 mm)
ッ
ニ ナ ッ
Preparation of plates
ㅂ
ド
ト
デ
ㅂ ㅄ
ㅄ
ㅅ
1
2
(E-1)
(E-2)
ㅂ
Prepared
M16 bolt
㊍
As shown in the right figure, prepare 6 sets of plates
ㅂ
and bolts.
1. Insert insulating collars
ㅄ
into the protective collar
ㅅ
, and put
them between plates
ㅂ
.
2. Pass the accessories over the prepared M16 bolt
㊍
in the order
shown in the figure, and secure them using the nut
ド
.
The bolt should be securely tightened to the torque given below.
(16~20 N•m)
•
Preparation of base
ㅁ
1
2
4
3
デ
ト
ド
ㅁ
ㅄ
ㅅ
(E-1)
ㅄ
(E-2)
Prepared M16 bolt
㊍
As shown in the right figure, prepare 2 sets of base
ㅁ
and bolts.
1. Insert insulating collars
ㅄ
into the protective collar
ㅅ
2. Put the protective collar
ㅅ
between the side plates of the base
ㅁ
3. While holding the collars, pass one prepared M16 bolt
㊍
through.
4. Fit washers on the bolt, and fasten in place with the nut
ド
.
The bolt should be securely tightened to the torque given below.
(16~20 N•m)
•
Preparation of the bracket 1
ㅌ
, bracket 2
ㅍ
and bracket 3
ㅎ
ㅌ
ㅍ
ㅎ
ㅉ
ㅉ
ㅊ
As shown in the figure on the right, adhere two gaskets to each of
the brackets, and prepare each pair of brackets in this way.