Panasonic TX-28DT30, Operating Instructions Manual

Page: 50 / 53

50
H
Service
Before requesting service, please refer to the trouble
--
shooting
guide on previous page to determine the symptoms. To obtain
service please contact your local Panasonic dealer quoting the
model number and serial number (both are located at the rear of
the TV).
H
TV Games / Home Computers
Extended use of TV games or home computerswith any television
set can cause a permanent ‘shadow’ on the screen. This type of
irreversible picture tube damage, can be limited by observing the
following points:
D
Reduce the brightness and contrast levels to a minimum
viewing level.
D
Do not operate the television set for a continuous period of
time while using TV games or home computers.
D
This type of picture tube damage, is not an operating
defect, and as such is not covered by the Panasonic
warranty.
H
Last Position Memory
Certain functions have a last position memory, i.e. the setting at
the time of switch
--
off will be the setting used when the receiver is
switched on again: --
Programme Tint (M.NTSC / NTSC only)
Mode Volume correction (in AV mode only)
AV Position Contrast
Volume Sharpness
NICAM Aspect mode
Bass Standby
Treble Artificial Intelligence (AI)
Balance Colour
Colour Balance Brightness
Status P -- NR
Teletext mode Decoder (AV2)
Ambience PC Connection
Preferred subtitles Modem Connection
H
Sleep Feature
If the set is not switched off when the TV station stops
transmitting, it will automatically go to standby mode after 30
minutes. This function will not operate when the TV is in AV
mode.
TX
--32DT30
TX
--28DT30
Power Source 220 -- 240V 50Hz A.C.
Power Consumption 119W 114W
Standby Consumption
3.7W (TV only)
17.7W (TV + DVB system set to record Timer programmes)
Picture Tube
Visible Diagonal
76cm 66cm
Audio Output
Music Power
Front Left / Right 20W x 2,
8
W
impedance
Dimensions
H
W
D
558mm
849mm
551mm
509mm
764mm
508mm
Weight (kg) 57 44
Receiving
Systems/
PAL I UHF E21
--
68
PAL 525/60
Playback of NTSC tape from some PAL Video recorders (VCR)
DVB Digital terrestrial services via UHF aerial input
Systems/
Band name
DVB Digital terrestrial services via UHF aerial input
M.NTSC Playback from M.NTSC Videorecorders (VCR)
NTSC (AV input only) Playback from NTSC Videorecorders (VCR)
Aerial
--
Rear UHF
Headphones -- Front 3.5mm, 8
W
impedance
AV
--
Rear
AV1 - - 21 pin socket - - Audio / Video in / out, RGB in
AV2 - - 21 pin socket - - Audio / Video in/out, S- -Video in, Q- -Link
AV4
- - 21 pin socket - - Audio / Video in / out, S- -Video in, RGB in
2 x RCA Audio Monitor Out
Data connections
MODEM -- 9 pin male D- -type connector - - max. 38.4kbps
SERIAL
--
9 pin female D- -type connector - - max. 38.4kbps
AV
--
Front AV3
--
S- -Video in, RCA Audio / Video in
Specifications are subject to change without notice. Weight and dimensions shown are approximate.
FOR YOUR GUIDANCE
SPECIFICATIONS