Panasonic TX-15TA1C, Operating Instructions Manual

Page: 6 / 52

6
PREPARING THE REMOTE CONTROL UNIT
Also refer to the label ‘‘Replacing the battery’’ on the back of the remote control unit.
Note:
Replace the tray and slide back the latch until it snaps in place.
Remove battery as shown below. Install the battery in the battery
tray. (Confirm that the positive pole marked “+” is facing up. )
Draw out the battery tray by sliding latch and pulling in the
direction of as show below.
1
3
Pull out the battery holder
Reinsert the battery holder
2
Replace the battery
If the remote control unit only works when held very close to the reception sensor, the battery is probably
exhausted.
In this case, please replace the battery with a new one.
“Replacing batteries” label
●
Do not drop the remote control unit, subject it to hard shock or step on it (this might cause
breakage of parts and malfunction).
●
Make sure there are no obstacles between the remote control unit and the remote-control
reception sensor on the monitor.
●
Do not use the remote control unit at the same time as a remote control unit for other
devices.
●
Replace the battery if the remote control unit no longer functions even when used close to
the monitor. For details, please refer to the label “Replacing the battery” on the back of the
remote control unit and to the instructions below.
Remove the insulation sheet
The lithium battery is included in the remote
control at the time of delivery.
Remove the insulation sheet to operate the
remove control.
Back of the Remote Control
the insulation sheet
Replacing the battery
Battery
(CR2025)
Rear
Precautions:
Rear