English
- 12 -
Connecting the IR Receiver
Before plugging the Display into the mains supply, connect the supplied IR receiver to the IR input on the
Display. Place the IR receiver in sight of your own remote control. Simply operate your remote control whilst
pointed at the IR receiver and it will relay the control signal to your Display.
Note : Do not expose the display to direct sunlight or strong light source during use.
Otherwise the remote control not work or malfunction may occur since the IR reciever of the display uses infrared rays.
Turning the Display On/O
ff
After connecting the Display to the mains set the main On/Off switch to the “1” position. The Display will switch
into standby mode. Press the
Standby
button on the remote or press the centre of the joystick in located on
the rear left side of the Display and hold it down for a few seconds to switch it on from standby.
Press the centre of the joystick in and hold it down for a few seconds or press the Standby button on the remote
to switch the Display into standby mode. To switch the Display off, set the On/Off switch to the “2” position.
2
3
98”/86”
75” / 65” / 55”
49” / 43”
3
1
Standby button
2
Joystick
3
On/Off Switch
(*)
(*)
The location of the On/Off switch may differ depending on the model.
LED Status
Status of the display
Power LED lit Green
Power on
Power LED lit Red
Power off (Standby mode)
Power LED Red&Green (slow)
Starting Up
Power LED Red&Green (fast)
Software update
(rear view)
(rear view)
