English
44
[Component/RGB-in select]
Select to match the signals from the source connected
to the PC IN terminal.
[Component]
Y, P
B
, P
R
/Y, C
B
, C
R
signals
[RGB]
RGB signals
[YUV/RGB-in select]
Select to match the signals from the source connected
to the DVI-D IN terminal.
[YUV]
YUV signals
[RGB]
RGB signals
[Sync]
This function operates only during PC input.
Setting RGB/PC sync signal
[Auto]:
The H and V sync or synchronized signal is
automatically selected. When both of them have
sync, H and V sync will be selected.
[on G]:
Uses a synchronized signal on the Video G signal,
which is input from the G connector.
Setting Component sync signal
[Auto]:
The H and V sync or synchronized signal is
automatically selected. When both of them have
sync, H and V sync will be selected.
[on Y]:
Uses a synchronized signal on the Video Y signal,
which is input from the Y connector.
[XGA mode]
This menu is displayed when the input signal is
analogue (Component/PC). This unit supports three
types of XGA signals with 60Hz vertical frequency
having different aspect ratios and sampling rates
(1024 × 768 @60Hz, 1280 × 768 @60Hz and 1366 ×
768 @60Hz).
[Auto]:
Automatically selected from [1024x768]/[1280x768]/
[1366x768].
Switch the setting to suit the input signal for better
display depends on the angle of view or display
resolution condition.
Note
●
After making this setting, be sure to make each
adjustment (such as [Auto setup]) on the [Position]
menu as necessary. (see page 34)
[Signal range]
Switches the dynamic range according to the input
signals below.
HDMI1 to HDMI4, DIGITAL LINK, DisplayPort, SLOT
(SDI1 to SDI4)
[Video(16-235)]:
If the input signal is the video range, Example: HDMI
terminal output for DVD player
[Full(0-255)]:
If the input signal is full range, Example: HDMI
terminal output for personal computer
[Auto]:
Switches the dynamic range automatically between
[Video(16-235)] and [Full(0-255)] according to the
input signal.
●
[Auto] cannot be selected during the DIGITAL LINK
and SLOT (SDI1 to SDI4) input.
[Stream setting]
This menu is displayed during DisplayPort input.
Set the display method for stream of the device
connected to the DisplayPort terminal.
[Auto]:
Automatically switches to the appropriate stream
according to the input signal.
[Single stream]:
Displayed as single stream.
[Input level]
This menu is displayed at PC IN input.
Adjustment of parts which are extremely bright and
hard to see.
- 32 to + 32:
(Level low) - (Level high)
[1080i/PsF]
Sets the mode of image processing most suitable for
the picture to display.
[Auto]:
Discriminates automatically according to the input
signal.
[i]:
Displays the picture signal with IP conversion
processing.
[PsF]:
Displays the picture signal with progressive
conversion processing.
[Noise reduction]
