41
Reduces power consumption
Press to select
“Power save”
“Standby save”
“PC Power management”
“DVI-D Power management”
“No signal power off”
“No activity power off”.
Press to select “On (Enable)” or “Off (Disable)”.
On (Enable)
Off (Disable)
Press to exit from Setup.
• Power save:
When this function is turned On, luminous level of the Plasma Display is suppressed, so
power consumption is reduced.
• Standby save:
When this function is turned On, power consumption of the microcomputer is reduced
during power supply standby (see page 15, 17, 18), so standby power of the set is reduced.
• PC Power management: When this function is set to On, it operates under the following conditions to turn the power
on or off automatically.
When no pictures (HD/VD sync signals) are detected for 30 or so seconds during PC signal
input:
Power is turned off (standby); the power indicator lights up orange.
When pictures (HD/VD sync signals) are subsequently detected:
Power is turned on; the power indicator lights up green.
Notes:
• This function operates only during PC signal input.
•
This function is effective when “Sync” is set to “Auto”, “Component / RGB-in select” is set
to “RGB” and during normal viewing.
• DVI-D Power management: When this function is set to On, it operates under the following conditions to turn the power
on or off automatically.
When no pictures (sync signal) are detected for 30 or so seconds during DVI signal input:
Power is turned off (standby); the power indicator lights up orange.
When pictures (sync signal) are subsequently detected:
Power is turned on; the power indicator lights up green.
Notes:
• This function operates only during DVI signal input.
•
This function is invalid during input from DVI-D Terminal Board (TY-FB11DD) and Dual
DVI-D Terminal Board for 3D (TY-FB30DD3D).
•
Depending on the type of terminal board equipped, this function may be invalid.
• No signal power off:
Equipment power supply is turned Off when there is no signal.
When this is set to “Enable”, the power supply of the unit goes Off 10 minutes after the input
signals stop.
• No activity power off: When this function is set to “Enable”, the power is turned off (standby) automatically when
there is no operation of the Plasma Display for 4 hours.
Starting from 3 minutes before the turn off, the remaining time will be displayed.
No activity power off 3min
Press any key to abort.
When the power is turned off due to this function, a message “Last turn off due to ’No
activity power off’.” is displayed next time the power is turned on.
Note:
During the screensaver is running, this function is disabled.
1
2
3
1/2
Signal
3D Settings
Screensaver
Extended life settings
Input label
Off
Standby save
Off
PC Power management
Off
No activity power off
Enable
OSD Language
English (UK)
Component/RGB-in select
RGB
Power save
Setup
No signal power off
DVI-D Power management
Off
Disable
