Panasonic SJ-MJ55GH, Service Manual

Page: 14 / 52

1. Set the battery and connect the remote controller. (The position of
the HOLD switch of remote controller is “OFF”.)
2. Turn off the power, and switch main unit’s HOLD switch off.
3. Press the VOL+( ), VOL-( ),
( ), and ( )keys on the
remote controller within two seconds. (asshown in Fig. 5 )
Fig. 5
4. When the adjustment mode is activated, “T0E ” will be displayed
on the LCD of remote controller. After “T0E ” is displayed, select
the desired adjustment item with the
button or button of
the remote controller. (If it is not displayed, perform the
procedures written above again.)
*In the display of T0E ~ TFE shown above, you must adjust T0E , T1E , T2E and T3E . You must
perform the adjustment by observing the order T0E T1E T2E T3E .
Note:
If it is going to perform “T2E” and “T3E”, without performing “T1E”, it will be displayed as “NG”.
If it is going to perform “T3E” when “T2E” is “NG”, it will be displayed as “NG”.