RQTX0165
3
Before use
Digital signals that can be played on this system
FCC Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Any unauthorized changes or modifications to this equipment would void the user’s authority to operate this device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Responsible Party:
Panasonic Corporation of North America
One Panasonic Way
Secaucus, NJ 07094
Support Contact:
Panasonic Consumer Electronics Company
Telephone No.: 1-800-211-PANA (7262)
•
•
•
•
Note
Playback of the following signals is also available when you make HDMI connections. (
pages 17 and 28)
– PCM signals with sampling frequencies of over 96 kHz
– Multi-channel signals with sampling frequencies of over 48 kHz
Depending on the connected equipment, the playback condition differs. (Playback may be impossible if not supported.)
See operating instructions of playback equipment for more information.
See “Glossary” (
page 38) for more detailed information on each signal.
•
•
Dolby Digital
DTS
PCM (2-channel)
Multi-channel LPCM
(Linear PCM)
DVD etc.
DVD etc.
CD, DVD audio etc.
(Signals with sampling
frequencies of up to 96 kHz)
Blu-ray disc, DVD audio etc.
(Signals with sampling
frequencies of up to 48 kHz)
Digital signals that can be played on this system
SC-HTR310 (RQTX0165-P) - 14.07.08.indd 3
7/16/2008 1:51:05 PM
