RQTX0165
12
Shelf assembly
Installing and assembling the rack
Glass top panel assembly
(Side view)
Adjust the included glass top panel
so that it lines up with the protrusion
on the back of the rack.
The glass top panel has the front side and back
side. Face up the front side with the sticker.
The nonslip sheet has been put on the top panel of
the rack. Do not remove the sheet when installing
the glass top panel.
•
•
Put the glass panel down slowly to
make sure its aligned with the rear of
the top panel of the rack (as shown
in the diagram).
Note
Lift up and down slowly not to make an impact on the glass.
1
2
Nonslip
sheet
Glass top panel
Protrusion
Sticker
Top panel of the rack
Glass top panel
Top panel of the rack
1
3
Hole
Groove (Under the shelf)
Shelf
Moulded dowel
Connection
Installing and assembling the rack
UNIT: mm (inches)
Dowel position
Upper
Middle
Lower
Compartment
H
Upper shelf 101 (
3
31
/
32
”)
131 (
5
5
/
32
”)
161 (
6
11
/
32
”)
Lower shelf 101 (
3
31
/
32
”)
71 (
2
25
/
32
”)
41 (
1
5
/
8
”)
W
448 (
17
5
/
8
”)
(both L and R)
D
354 (
13
15
/
16
”)
Insert the moulded dowel (included) into
the dowel hole on one side.
Insert the shelf (included) at an angle
and adjust it so that the shelf groove is
attached to the molded dowel.
Hold the shelf, insert the moulded dowel
into the dowel hole on the other side. Set
the shelf horizontally.
The height of the shelf can be adjusted at 3 different
levels.
Change the position of the dowels to move the shelf up or
down.
Insert the moulded dowel not to lose even when the shelf
is not set.
•
•
•
2
SC-HTR310 (RQTX0165-P) - 14.07.08.indd 12
7/16/2008 1:51:32 PM
