RQT8
59
3
8
Si
mp
le
S
etu
p
Conserving power
The main unit consumes a small amount of power, even when it is turned off (For U.S.A. and Canada: approx. 0.4 W or for other areas: approx.
0.9 W). To save power when the unit is not to be used for a long time, unplug it from the household AC outlet.
You will need to reset some memory items after plugging in the unit.
[Note]
The included AC power supply cord is for use with this unit only. Do not use it with other equipment. Also, do not use cords for other equipment with
this unit.
Do not:
≥
mix old and new batteries.
≥
use different types at the same time.
≥
heat or expose to flame.
≥
take apart or short circuit.
≥
attempt to recharge alkaline or manganese batteries.
≥
use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
∫
Use
Aim at the display (
➜
page 9), avoiding obstacles, at a maximum
range of 7 m (23 feet) directly in front of the unit.
STEP
4
Radio and AC cord connections
FM ANT
75
75
AC IN
AC IN
AM
ANT
EXT
LOOP
LOOP
ANT GND
Adhesive tape
To household AC outlet
[For\areas\except\U.S.A.\and\Canada]
≥
If the power plug does not fit your
AC outlet
Use the power plug adaptor (included).
If it still does not fit, contact an electrical
parts distributor for assistance.
AC power
supply cord
Main unit
AM loop antenna
Stand the antenna up on its base.
Place the antenna where reception is best.
Keep loose antenna cable away from other wires
and cables.
Click!
AM loop antenna
FM indoor antenna
AC power supply cord
\U.S.A.\and\Canada]
Power plug adaptor
\Areas\except\U.S.A.\and\Canada]
FM indoor antenna
Affix this end of the
antenna where
reception is best.
≥
Connect the AC power supply cord after all other connections are complete.
≥
Using an outdoor antenna (optional) (
➜
page 25).
The illustration shows the model for U.S.A. and Canada.
\Others]
Re-tighten the terminal
screw.
Loosen the terminal screw with
a Phillips-head screwdriver.
White
Red
Black
While pushing, insert the wire fully.
STEP
5
Preparing the remote control
R6/LR6, AA
1
3
2
Remote control
Batteries
Insert so the poles (
i
and
j
) match those in the remote control.
≥
Do not use rechargeable type
batteries.
Ra
dio and A
C
cor
d
connec
tions
/ Pr
epa
ring the
remote
contr
o
l
8593En_p03-11.fm Page 8 Tuesday, January 10, 2006 5:23 PM
