VQT2R70
25
Troubleshooting and
other information
Error messages/Using with headphones/Speci
fi
cations
Error messages
Display
Check point/Cause/Countermeasure
Pages
CANCEL MUTE FUNCTION
(Scrolling)
• The test signal is not output while muting is on. Cancel muting for operation.
20
MUTE
(Blinking)
• This is always displayed while muting is on.
20
NOT POSSIBLE FOR
THIS INPUT SOURCE
(Scrolling)
• You cannot use Dolby Virtual Speaker, SFC and Dolby Pro Logic for dual
sounds.
—
NOT POSSIBLE FOR
THIS PCM SOURCE
(Scrolling)
• You cannot use Dolby Virtual Speaker, SFC and Dolby Pro Logic effect with
PCM signals with sampling frequency of over 48 kHz.
17
NOT POSSIBLE WHEN USING
HEADPHONES
(Scrolling)
• You cannot use the sound field effects when using headphones.
25
REMOTE 2
REMOTE 1
• Set the same remote control code for this main unit and remote control. When “
REMOTE 2
”
is displayed, set the code to “
2
” on the remote control in step
4
of procedure “When other
equipment (mini component system, AV amp, etc.) manufactured by Panasonic operates
with the remote control operations of this system”. When “
REMOTE 1
” is displayed, set the
code to “
1
” on the remote control in step
4
in the same way.
24
SWITCH OFF POWER
(Scrolling)
• While “
F70
” is displayed, all operations but turning ON/OFF operation are not
available. Turn off the system, unplug the AC power supply cord, and consult your dealer.
—
TURN OFF DTS FIX MODE
(Scrolling)
• When each input is fixed to DTS (DTS FIX), the sound field effects cannot be
canceled even if you press [–SETUP, OFF]. Cancel DTS FIX.
24
U701
• The equipment connected by the HDMI cable is not compatible with this system’s copyright protection technology.
—
U703
• A problem has occurred with the HDMI connection. Try the following to correct
the problem. Consult your dealer if the error code remains on the display.
– Turn the connected equipment off and on again.
– Disconnect the HDMI cable then reconnect it.
– Do not connect more than 2 sets of equipment to this system’s output.
—
U704
• The system received incompatible video signals through HDMI connection.
Check the settings of the connected equipment.
—
Speci
fi
cations
Using with headphones
Note
• Avoid listening for prolonged periods of time to prevent hearing
damage.
• Multi-channel signals are forcibly converged to 2-channel and
output. (2CH MIX)
However, for DVD audio, the front left and right signals are output.
Turn down the volume closest to the minimum value.
• Plug type: ø 3.5 mm (1/8 in.) stereo mini plug
g
PRE AMPLIFIER SECTION
Input sensitivity / Input impedance
TV, AUX3
600 mV / 47 k
Ω
S/N ratio (IHF A)
BD/DVD, TV, AUX1,
AUX2 (Digital Input)
80 dB (IHF '66)
Tone controls
BASS
50 Hz, + 6 to –6 dB
TREBLE
20 kHz, + 6 to – 6 dB
Input/Output terminal
Audio Input
Analog Input ( TV, AUX3 )
2
Optical Digital Input ( TV, AUX2 )
2
Audio Output
Audio Output ( Front L/R, Surround L/R )
4
Subwoofer Output
1
Headphone Output ( 16 to 64
Ω
)
1
Video/Audio
HDMI Input ( BD/DVD, AUX1 )
2
HDMI Output ( TO TV (ARC))
1
This system supports “HDAVI Control 4” function.
g
MAIN UNIT GENERAL
Power supply
AC 120 V, 60 Hz
Power consumption
16 W
In standby condition
0.5 W
In standby condition ( HDMI off mode )
0.2 W
Dimensions ( W x H x D )
430 mm x 59 mm x 262 mm
(16-15/16" x 2-5/16" x 10-5/16")
Mass [ Weight ]
Approx. 2 k
g
(4.4 lb.)
Operating temperature range
0°C to 40 °C (32°F to 104 °F)
Operating humidity range
20 % to 80 % RH (no condensation)
g
WIRELESS SECTION
Frequency of the using band
2.4000 GHz to 2.4835 GHz
Number of using channels
3
The reaching distance
15 m (49 ft)
∗
1
∗
1 It is under the condition as follows.
At same room indoor, there is not an obstacle
between the main unit and the speaker.
And installing a main unit in the position with
equal to or more than 50 cm height.
SPEAKER
g
POWER AMPLIFIER SECTION
∗
2
RMS output power
10 % total harmonic distortion
Woofer Speaker ch
60 W (100 Hz, 3
Ω
)
Mid High Speaker ch
20 W (1 kHz, 8
Ω
)
System Total Power
∗
3
160 W (80 W x 2)
FTC output power
1.0 % total harmonic distortion
50 Hz to 250 Hz
Woofer Speaker ch
37 W (3
Ω
)
250 Hz to 20 kHz Mid High Speaker ch
13 W (8
Ω
)
System Total Power
∗
3
100 W (50 W x 2)
g
SPEAKER SECTION
∗
2
2-way 5 speakers system (Bass reflex type)
Woofer part
12 cm cone type x 1
Mid High part
2.4 x 10 cm flat type x 4
g
SPEAKER GENERAL
∗
2
Power supply
AC 120 V, 60 Hz
Power consumption
20 W
Wireless Link Standby
0.8 W
In Standby condition
0.1 W
Dimensions ( W x H x D )
290 mm x 1231 mm x 290 mm
(11-13/32" x 48-15/32" x 11-13/32")
Mass [ Weight ]
Approx. 3.9 k
g
(8.6 lb.)
Operating temperature range
0°C to 40°C (32°F to 104°F)
Operating humidity range
20 % to 80 % RH (no condensation)
∗
2: per 1 speaker
∗
3: use 2 speakers
Note: 1. Specifications are subject to change
without notice.
2.
Total harmonic distortion is measured by
the digital spectrum analyzer.
3.
Total harmonic distortion is measured by
using AES17 filter.
MAIN UNIT
W
(Headphone) jack
Headphones
(not included)
5%<6228364'PKPFF
5%<6228364'PKPFF
ඦ೨
ඦ೨
