6
Si
mp
le
S
etu
p
Po
s
it
io
n
in
g
RQ
TX00
87
ENGL
ISH
∫
Attaching to a wall
You can attach all of the speakers (except subwoofer) to a wall.
≥
The wall or pillar on which the speakers are to be attached
should be capable of supporting 10 k
g
per screw. Consult a
qualified building contractor when attaching the speakers to a
wall. Improper attachment may result in damage to the wall and
speakers.
1
Drive a screw (not included) into the wall.
2
Fit the speaker securely onto the screw(s) with the hole(s).
Reattaching the speaker cable to the stand
1
Remove the eight screws from the stand, and remove the speaker
net.
2
Position the cable.
3
Attach the speaker net with the screws.
∫
Fitting speaker stands
(not included)
(Except front speakers and subwoofer)
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance
between screws as shown in the diagram.
≥
The stands must be able to support over 10 k
g
.
≥
The stands must be stable even if the speakers are in a high
position.
e.g.
Center speaker
Speaker installation options
Preparation for front speakers
§
Use the cable from the stand by releasing it from the grooves at
both ends.
3
Cover plate
Tighten securely.
Connect the cable
§
(
➜
4).
‰
7.0 to 9.4 mm
4 to 6 mm
Wall or pillar
‰
4.0 mm
At least 30 mm
Front speaker
Attach to a wall without the
base and the stand
Center speaker
200 mm
106 mm
Surround speaker
In this position,
the speaker will
likely fall if moved
to the left or right.
Move the speaker
so that the screw is
in this position.
e.g.
DO
DO
NOT
340 mm
Screw
Press the cable into
the groove.
Approx.
15 cm
Cable
Speaker stand
(not included)
Plate thickness plus
7 mm to 10 mm
5 mm, pitch 0.8 mm
Metal screw holes
For attaching to
speaker stands
60 mm
6
SC-PT465E-RQTX0087-1R_eng.book Page 6 Wednesday, January 30, 2008 4:13 PM
