#
Loosen the screw by turning it
anticlockwise.
$
Release the two hooks at the
top of the cable cover.
%
Pull the cable cover to the
rear to remove it from the
projector.
62-E
NGLISH
Putting the power cord and remote control unit away
#
Put the remote control unit
into the cable cover with the
buttons facing downward to
prevent them from being
pressed.
$
Put the power cord and other
cables into the cable cover.
%
Put the Velcro through the
hole, and tape it to prevent
the cables from dropping out.
&
Insert the hook 1 of the cable
cover into the mounting holes
in the projector.
'
Push in the hook 2 until it
locks into place.
(
Tighten the screw by turning it
clockwise.
Removing the cable cover
Installing the cable cover
#
$
%
Hook1
Hook2
Velcro
Remote control unit
(Infrared emitter)
#
%
˛
$
˛
$
˛
'
˛
&
˛
(
˛
'
NOTE:
Do not lift up the projector by holding the cable cover, otherwise the cable
cover might come off.
Using the cable cover
Summary of Contents for PTL785U - LCD PROJECTOR UNIT
Page 87: ...FRANÇAIS 87 Others ...
